Instructions

DSX-600 Series CableAnalyzer
Users Manual
28
% Tested does not show if your project contains only a Next ID
list. See “About Next ID Sets” on page 83 for more information
about the Next ID list.
 This icon shows when the tester’s link interface adapter
is connected to the adapter on a remote and the remote is
turned on.
 The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service on the tester. See “About the Asset Management Service”
on page 93.
 This icon shows when the talk function is on. To use the
talk function:
1 Connect the main and remote testers together through a
link that has one or more good wire pairs.
2 Connect headsets to the headset jacks on the testers.
3 Press the button on one of the headset microphones or
press  on the remote, then speak into the
microphone.
Make Sure Your Tester is Ready to Certify
Cabling
To make sure your tester meets its accuracy specifications, follow
these guidelines:
 Keep the tester’s software current. The latest software is
available on the Fluke Networks website. See “Update the
Software” on page 101.
 Set the reference for the twisted pair adapters every 30 days.
See page 29.
 Make sure that you select the correct cable type for the job,
and that the NVP for the cable is correct. See Table 2 on
page 32.