Instructions

ManualsBrandsFLUKE NETWORKS ManualsTest EquipmentCable tester

Table Of Contents

FindFiber Instruction Sheet

PN 3314833 September 2008, Rev. 1 10/10

All product names are trademarks of their respective companies.

FindFiber

™

Source

Instruction Sheet

The FindFiber

™

source is used with a SimpliFiber

Pro optical

power meter to identify fiber connections at patch panels.

The source comes with the following:

•

Two AA alkaline batteries

•

Instruction Sheet

The FindFiber-6 kit comes with the following:

•

Six FindFiber sources

•

Twelve AA alkaline batteries

•

Instruction Sheet

If something is damaged or missing, contact the place of

purchase immediately.

Safety Information

WWarning: Class 1 Laser

To avoid possible eye damage caused by hazardous

radiation:

•

Never look directly into optical connectors. Some

sources produce invisible radiation that can

permanently damage your eyes.

•

Never turn on the source unless a fiber is

attached to the port.

•

Do not use magnification to view the optical

outputs without proper filtering.

•

Use of controls, adjustments, or procedures not

stated herein might result in hazardous radiation

exposure.

Summary of content (6 pages)

PAGE 1
FindFiber ™ Source Instruction Sheet The FindFiber™ source is used with a SimpliFiber® Pro optical power meter to identify fiber connections at patch panels. The source comes with the following: • Two AA alkaline batteries • Instruction Sheet The FindFiber-6 kit comes with the following: • Six FindFiber sources • Twelve AA alkaline batteries • Instruction Sheet If something is damaged or missing, contact the place of purchase immediately.
PAGE 2
WCaution To avoid damaging fiber connectors, to avoid data loss, and to ensure maximum accuracy of test results: • Use proper cleaning procedures to clean all fiber connectors before every use. Neglecting this step or using improper procedures can cause unreliable test results and may permanently damage the connectors. • Cover all connectors with protective caps when not in use. • Never connect the source to an active network. Doing so can disrupt network operations.
PAGE 3
Locating Fibers 1 Connect a SimpliFiber Pro meter and one or more FindFiber sources to the fiber links as shown below. 2 Turn on the meter and the FindFiber sources. 3 To change the number transmitted by a FindFiber source, turn the source off, hold down the power key for about 4 seconds; then release the key when the desired LED turns on. Note If you are using a SimpliFiber Pro source, press I on the source.
PAGE 4
Registration Registering your product with Fluke Networks gives you access to valuable information on product updates, troubleshooting tips, and other support services. To register, fill out the online registration form on the Fluke Networks website at www.flukenetworks.com/registration. Contacting Fluke Networks www.flukenetworks.com support@flukenetworks.
PAGE 5
Specifications Operating temperature -10ºC to +50ºC Storage temperature -20ºC to +50ºC Emitter type Laser Source connector Fixed SC FindFiber ID numbers 1 through 8. Default is 3. Power indicator LED Power requirement 2 AA alkaline batteries Battery life* >80 hours (typical) Automatic power-off 30 minutes Low battery indicator Blinking LED Size 7.1 in x 1.3 in x 1.0 in (17.9 cm x 3.2 cm x 2.5 cm) Weight 4.
PAGE 6
LIMITED WARRANTY AND LIMITATION OF LIABILITY Fluke Networks mainframe products will be free from defects in material and workmanship for one year from the date of purchase. Parts, accessories, product repairs and services are warranted for 90 days, unless otherwise stated. Ni-Cad, Ni-MH and Li-Ion batteries, cables or other peripherals are all considered parts or accessories.