Instructions

Locating Fibers
1 Connect a SimpliFiber Pro meter and one or more FindFiber
sources to the fiber links as shown below.
2 Turn on the meter and the FindFiber sources.
3 To change the number transmitted by a FindFiber source, turn
the source off, hold down the power key for about 4 seconds;
then release the key when the desired LED turns on.
Note
If you are using a SimpliFiber Pro source, press I on the
source. The multimode source is fixed at ID 1, the
1310 nm/1550 nm singlemode source is fixed at ID 2,
and the 1490 nm/1625 nm source is fixed at ID 3
4 On the meter, press M until FindFiber
™
appears.
5 If the meter and a FindFiber source are connected, the
number indicated by the source’s LED appears on the meter.
If the meter and source are not connected, appears
on the meter’s FindFiber display.
ffu01.eps
Using the FindFiber Source
ID #3
ID #4
ID #5
SimpliFiber Pro
meter