Product Manual

4-1
Chapter 4
View Memory
Introduction
This chapter provides information about how to view measurement data that is manually
or automatically saved to the Product memory.
The Product has an internal memory that stores measurement data that can be viewed.
Measurement data in Meter mode and Sequence mode shows separately. The total
memory usage can be viewed in the Setup menu.
View Data Saved in Meter Mode
To view measurement data that is saved in Meter mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – METER shows on the upper left corner of the display.
3. View the memory items, and push the Next softkey to view next page as required.
4. Use 1 to cycle through these four data sets: mΩ.V, VDC, VAC, and Ripple.
hpo063.jpg
Delete Data Saved in Meter Mode
To delete data saved in meter mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – METER shows on the upper left corner of the display.
3. When the data to be deleted shows on the display, push the More softkey.
a. To delete data entries one by one, use and L to highlight a data entry, and
then push the Delete softkey.