Installation Manual

713 English Instruction Sheet

Page

• Remove the test leads from the calibrator

before you open the battery door.

• Make sure the battery door is closed and

latched before you operate the calibrator.

• Do not operate the calibrator if it is damaged.

• Do not operate the calibrator around explosive

gas, vapor, or dust.

• To avoid a violent release of pressure in a

pressurized system, shut off the valve and

slowly bleed off the pressure before you attach

or detach the calibrator pressure fitting to the

pressure line.

• When servicing the calibrator, use only

specified replacement parts

Caution

To avoid overpressure damage, do not apply

pressure that exceeds the following:

• Model 713 30G: 3X top of range (90 psi, 620 kPa,

6.2 bar)

• Model 713 100G: 2X top of range (200 psi, 1380

kPa, 13.8 bar)

To avoid corrosion in the pressure sensor, use the

calibrator only with media compatible with glass,

ceramic, silicon, RTV, type 316 stainless steel, and

nickel.

To avoid mechanically damaging the calibrator, do

not apply torque between the pressure fitting and

the calibrator case. See the figure for the proper

use of tools.