Installation Manual

713 English Instruction Sheet
Page 5
Getting Acquainted with the Calibrator
Press the green
O
pushbutton to turn the calibrator on and off.
The calibrator displays pressure and current measurements
simultaneously. See the figure below.
The upper part of the display shows the gage pressure applied to
the pressure fitting. Press
U
to select a different pressure unit.
When you cycle the power off and on, the calibrator retains the
pressure unit you last used.
The lower part of the display shows the current (up to 24 mA)
applied to the current (mA) inputs. The current inputs are fused
with a 0.125 A, 250 V fast fuse (Littelfuse type 2AG).
Current mA
measurement
Pressure
measurement
HOLD
0-100psi 0-689kPa
RANGE
200psi 1378kPa
MAX
713 100G
PRESSURE
CALIBRATOR
DAMPUNITS
MIN
MAX
ZERO
CLR
HOLD
Pressure
fitting
Current input
kf05f.eps