Operation Manual

3. Assembly

WARNING: Stop the unit and unplug the extension cord before opening the

inlet cover or attempting to install or remove the blower tube or vacuum tubes.

The motor must be stopped and the impeller blades no longer turning to avoid

serious injury from the rotating blades.

Fitting the blower tube:

2 3

1. Align the grooves on the blower tube

with the grooves on the

blower outlet

2. Push the blower tube onto the blower outlet until it snaps into

place; tube is secured to blower by tube release button

3. To remove the blower tube, press the tube release button

while pulling on tube.

NOTE: A safety switch will prevent the unit from starting if the

blower tube is not installed correctly.

Fitting the vacuum tubes:

8 4

1. Open the inlet cover

by releasing the latch

as shown

and pulling up on the vacuum assist handle

2. Allow latch to snap into rear handle of blower

Ensure mains cable

remains free.

NOTE: There are 2 vacuum tubes, an upper tube

and a lower

tube

The upper tube has a hinge and hooks on one end and is cut

straight on both ends. The upper tube attaches to the blower unit.

The lower tube has a curved end that you point toward the ground

during vacuum use. The lower tube attaches to the upper tube.

3. To attach the lower vacuum tube

to the upper vacuum

tube

, first align the seams of the two tubes.

Then, press the two tubes together until the lower tube is

fully seated in the upper tube.

9667594-01_9667594-62 PowerVac 3000 3000-20.960.01.indd 20 19.06.15 12:38