Operation Manual

WARNING: If the unit becomes clogged, stop the unit and unplug the

extension cord. Wait until the impeller has completely stopped turning,

then remove the vacuum tubes. Carefully reach into the vacuum opening

and clear out the clogged debris.

This will reduce possible personal injury from the impeller.

Removing an object from the

air intake:

1. Remove the vacuum tubes.

2. Carefully reach into the vacuum opening and clear out the air

intake area. Clear all debris from impeller.

3. Inspect the impeller for cracks. If cracked or damaged,

do not use the unit. Have parts replaced by your authorized

service dealer. Do not attempt to replace them yourself.

7. Troubleshooting

WARNING: Always stop unit and unplug the extension cord before

performing all of the recommended remedies below except remedies

that require unit to be operating.

The motor must be stopped and the impeller blades no longer turning to

avoid serious injury from the rotating blades.

Problem Possible cause Remedy

Unit fails to operate. 1. Switch in the OFF (0) position. 1. Slide switch to

ON (I) position.

2. Extension cord disconnected. 2. Reconnect extension cord.

3. Circuit breaker tripped,

or fuse blown.

3. Reset circuit breaker or

fuse.

4. Blower tube, elbow tube,

and/or vacuum tube not

installed correctly.

4.Check tube installation.

5. Collection bag is full. 5. Empty collection bag.

6. Mechanical failure. 6. Contact your authorized

service dealer.

Unit vibrates abnormally. 1. Mechanical failure. 1. Contact your authorized

service dealer.

Impeller will not

turn freely.

1. Debris in air intake area. 1. Clean unit. Remove any

debris.

2. Mechanical failure. 2. Contact your authorized

service dealer.

For any other malfunctions, please contact the Flymo

service department. Repairs must be carried out by Flymo

service departments or specialist dealers authorised by

Flymo.

9667594-01_9667594-62 PowerVac 3000 3000-20.960.01.indd 26 19.06.15 12:38