Instruction Manual

10
❏
6. Connect a 6" [150mm] servo extension wire to the fl ap
servo wire.
❏
7. Glue the servo into position as shown in the illustration
at step 13—CA may be used, but will be diffi cult to remove
from the servo if you ever want to remove it for another model
later—something fl exible such as Shoe Goo or canopy glue
is recommended for gluing in servos.
Cut
❏
8. If necessary, cut the tab from the servo wire extension
so it can be plugged into the Y-harness in the receiver.
❏
9. Connect the fl ap servo to whichever channel in your
receiver is controlled by the switch or dial on your transmitter
you wish to operate the fl aps—some prefer using a switch, but
most prefer a dial so the fl aps can be moved incrementally. It
is not necessary to join the wing to the fuselage at this time.
ON
❏
10. Same as was done for the elevator and rudder, turn on
the transmitter and connect the battery to the ESC.