Instruction Manual

15
Aileron Throw Flap Throw
Elevator Throw
Rudder Throw
❏
3. Note that the throw measurements for the elevator, rudder
and fl aps (if used) are taken at the widest part (front to back)
of each surface, but the aileron throw is measured at the split
between the fl aps and elevator (whether or not you have set
up the optional fl aps and cut the two apart).
Recommended Control Surface Throws
DEGREES
ELEVATOR
LOW RATEHIGH RATE
12 º
Up
12 º
Down
18º
Up
18º
Down
AILERONS
11º 11º19 º 19 º
RUDDER (R&L)
14 º 14 º19 º 19 º
FLAP
22º
Less Control Throw
More Control Throw
More
Control
Throw
Less
Control
Throw
❏
4. If necessary, use the programming in your transmitter or
mount the pushrods in different holes in the control horns or in
the servo arms to increase or decrease the elevator throw as
required. Moving the pushrods inward in the servo or outward
on the control surface horn decreases control throw. Moving
the pushrods outward on the servo or inward on the control
surface increases the throw.
❏
5. Measure and adjust if necessary the control throws for
the rudder, ailerons and fl aps the same way.
Recommended Control Surface Throws
INCHES
ELEVATOR
LOW RATEHIGH RATE
1/2"
Up
1/2"
Down
3/4"
Up
3/4"
Down
AILERONS
3/8" 3/8"5/8" 5/8"
RUDDER (R&L)
3/4" 3/4"1" 1"
FLAP
7/8"
Recommended Control Surface Throws
MILLIMETERS
ELEVATOR
LOW RATEHIGH RATE
13mm
Up
13mm
Down
19 mm
Up
19 mm
Down
AILERONS
10mm 10mm16 mm 16 mm
RUDDER (R&L)
19mm 19mm25mm 25mm
FLAP
22mm