Instruction Manual

ASSEMBLY

Install the Receiver (Rx-R Only)

❏

1. Cut strips from the included, adhesive-backed hook-

and-loop material. Stick one to the back of your receiver and

the other inside the fuselage as shown—the softer, “loop”

side goes on the receiver and the rougher, “hook” side goes

in the fuselage.

(White/Orange)

Receiver

+ (Red)

− (Black/Brown)

❏

2. Connect the servos and the Y-harness to the receiver

as shown.

Channel 1 (aileron) – dual Y-harness

Channel 2 (elevator) – elevator servo

Channel 3 (throttle) – electronic speed control (ESC)

Channel 4 (rudder) – rudder servo

❏

3. Mount the receiver to the Velcro

strip in the fuselage.

Hook Up the Elevator and Rudder

Rx-R, Tx-R, and RTF

❏

1. Flex the elevator up and down and the rudder back and

forth several times to break them in.

❏

2. Fit the vertical stabilizer (ﬁ n) into the horizontal stabilizer

(stab).