Manual

™

yzoneplanes.com

Principle

Instruction Manual

BATTERY HATCH REMOVAL

WING INSTALLATION

REQUIRED

● AirCore Power Core (FLZA6400)

● AirCore Battery (FLZA6401)

● SLT Compatible Radio System

● AirCore 2S LiPo AC/DC Charger (FLZA6411)

FLIGHT SETUP

Because transmitters other than the Tactic transmitters

may be used, the following information is included to

properly set the throws and C.G. (center-of-gravity) on

the AirCore Principle.

The measurements are taken at the widest part of the

control surface.

Rudder Throw 1/4 in [6 mm] 24 deg. Left and Right

Elevator Throw 9/32 in [ 7mm] 15 deg. Up and Down

CG Location on the Wing 1-1/8" [29mm] – 1-5/16" [33mm]

from the leading edge, on the bottom of the wing.

PAGE 1
Principle Instruction Manual BATTERY HATCH REMOVAL REQUIRED ● ● ● ● AirCore Power Core (FLZA6400) AirCore Battery (FLZA6401) SLT Compatible Radio System AirCore 2S LiPo AC/DC Charger (FLZA6411) FLIGHT SETUP Because transmitters other than the Tactic transmitters may be used, the following information is included to properly set the throws and C.G. (center-of-gravity) on the AirCore Principle. WING INSTALLATION The measurements are taken at the widest part of the control surface.
PAGE 2
If possible, always land directly into the wind. OPTIONAL INSTALLATION OF THE LANDING GEAR Gradually reduce power when you are close to the landing spot. When close to the ground and about to touch down, pull the elevator stick back slightly to raise the nose of the model and slow the landing speed to “flair” for landing. Unplug and remove the battery from the model and switch off the transmitter. Allow the motor to cool between flights.