User guide

Increased Elevator Throw for

Expert Pilots (Optional)

Pilots who have mastered ﬂ ying their Piper Super Cub with

the recommended control throws, or pilots who are already

experienced, may increase the elevator throw as shown

below for even more maneuverability.

❏

1. Loosen the screw in the screw-lock connector on the

elevator servo arm and remove the screw in the servo arm.

Remove the elevator servo arm from the elevator servo.

❏

2. Remove the retainer, then switch the screw-lock

connector from the inner hole to the outer hole. Replace the

retainer on the screw-lock connector, then replace the servo

arm on the servo with the screw. Center the elevator the same

way you did before with the radio on and tighten down the

screw in the screw-lock connector to lock the pushrod down.

This should be the

new elevator throw:

ELEVATOR

(EXPERT)

5/8"

[15.9mm]

14˚

5/8"

[15.9mm]

14˚

Down

Mount the Wing

❏

1. For balancing the model later, use a ﬁ ne-point felt-tip

pen to mark three balance lines across the bottom of the

wing 2" [51mm], 2-1/4" [57mm] and 2-1/2" [64mm] back from

the leading edge. The line in the middle is the recommended

starting balance point and the forward and aft lines mark the

forward and aft balance points.

❏

2. Connect the aileron servo wire to the aileron servo

extension coming from the receiver.