User guide

5
5
ASSEMBLE THE MODEL
Mount the Main Landing Gear
❏
1. Remove the preinstalled 2 x 15mm Phillips screws from
the aft landing gear mount on the bottom of the fuselage.
❏
2. Press the landing gear wire in the left main landing gear
into the landing gear mount. Then, reinstall the 2 x 15mm
Phillps screw into the aft mount and through the gear, but
don’t tighten it all the way down yet (the screw will be removed
and reinstalled again later when attaching the wing struts).
Mount the right main landing gear the same way.
❏
3. Remove the small screw from the plastic landing gear
wire connector that is not already holding in the other gear
wire. Insert the other landing gear wire into the connector
making sure it is fully seated. Reinstall the screw using care
not to over-tighten it. Mount the end of both gear springs to
the front, inner mount with 2 x 5mm Phillips screws.
Mount the Vertical & Horizontal
Stabilizers (Fin and Stab)
❏
1. Flex the elevators up and down a few times to loosen
them up so they move easier.
❏
2. Insert one of the pushrod wires part way up through the
elevator pushrod guide tube in the fuselage.