User Manual

6
Adjust the elevator and rudder
trims so the plane flies straight
and horizontal when the sticks
are free.
FLIGHT
Continue circling left in an oval pattern until you’re accustomed
to flying. If the plane nose dips, add a slight amount of up
elevator control.
Release the
elevator stick.
Move the
control sticks
slowly.
Turn the rudder to the right and then release the control stick.
Once the plane levels off, the circle is complete.
LANDING
When the battery runs low, the auto-
cut system will stop the propeller
from spinning. Flight times will be
7–10 minutes.
When landing, make a wide turn with
the wind, and then land into the wind.
Landing
Course
AFTER LANDING
1. Always disconnect the
battery before turning off
the transmitter. Hold the
connector when disconnecting
the battery. Do not pull on the
cord.
2. Then, switch the transmitter
OFF.
CAUTION: The battery may be hot after a flight.
Allow the battery to cool down before recharging.
AFTER-FLIGHT MAINTENANCE
1. Remove the battery from the
airplane when not in use.
2. For the next flight, check that
no screws have loosened and
replace any scratched or
damaged parts.
3. Clean away any dirt etc.
and perform any needed
maintenance.
TRANSMITTER MODE SELECTION
As supplied, the transmitter is in Mode 2.
NOTE: The transmitter can be used in Mode 1 or Mode
2 with the mode change switch. After the Mode has been
changed, the throttle stick spring is cancelled.
1. Move the left and right sticks
to the neutral position.
Neutral
Position