Integration Instructions

Document Information Page 21 of 31
FSS JODY-W263 Integration Instructions Rev 02.docx
www.foresightsports.com
Figure 5: Coplanar micro-strip dimension specification
Item
Value
S
200 µm
W
700 µm
T
35 µm
H
800 µm
𝜀
r
4.3
Table 12: Coplanar micro-strip specification
The mechanical dimensions of the module board’s microstrips and position of the pi network
impedance matching components are shown in Figure 6. Figure 7 shows the components used
for the PI network impedance matching. Here only series 0 ohm resistors are used. The inner
layers have the same dimensions and are filled with ground. No RF traces are routed in these
layers.
The antenna ports shown in Figure 4 on the right hand side are from top to bottom: ANT1,
ANT0, and ANT2. ANT2 is not used and shall be left unconnected.
Figure 6: Module board Antenna micro strip implementation