Integration Instructions

Document Information Page 30 of 31
FSS JODY-W263 Integration Instructions Rev 02.docx
www.foresightsports.com
9 Information on test modes and additional test
For end host implementation the user must refer to the manufacturer integration manual to
implement software/firmware that can be used to manipulate the module configuration and put
it into to special test modes, set and verify regional power limits and any debugging required.
10 Additional test requirements
Foresight Sports warrants that the modular transmitter fulfills the FCC/ISED regulations when
operating in authorized modes on any host product given that the integrator follows the
instructions as described in this document.
⚠ The modular transmitter approval of JODY-W263, or any other radio module, does not
exempt the end product from being evaluated against applicable regulatory demands.
The evaluation of the end product shall be performed with the JODY-W263 module installed
and operating in a way that reflects the intended end product use case. The upper frequency
measurement range of the end product evaluation is the 10th harmonic of 5.8 GHz as described
in KDB 996369 D04.
The following requirements apply to all products that integrate a radio module:
• Subpart B - UNINTENTIONAL RADIATORS
To verify that the composite device of host and module comply with the requirements of
FCC part 15B, the integrator shall perform sufficient measurements using ANSI 63.4-
2014.
• Subpart C - INTENTIONAL RADIATORS
To validate that the fundamental and out of band emissions of the transmitter part of
the composite device complies with the requirements of FCC part 15C, it is required that
the integrator carries out sufficient verification measurements using ANSI 63.10-2013.