Integration Instructions
Document Information Page 5 of 31
FSS JODY-W263 Integration Instructions Rev 02.docx
www.foresightsports.com
1 List of applicable FCC rules
The following FCC rules are applicable to the equipment:
• CFR 47, Part 15, Subpart C
• CFR 47, Part 2, Subpart J – Radiofrequency radiation exposure: portable devices
2 Summary of operational use conditions
2.1 Antenna configuration
In addition to the general requirement to use only authorized antennas, the grant also requires a
separation distance of at least 20 cm from the antenna(s) to all persons. The antenna(s) must not
be co-located with any other antenna or transmitter (simultaneous transmission) as well. If this
cannot be met, a Permissive Change as described below must be made to the grant.
☞ In order to support verification activities that may be required by certification laboratories,
customers applying for Class-II Permissive changes must implement the setup described in
Radio Test Guide for NXP based modules.
If the module is to be co-located with another transmitter, additional measurements for
simultaneous transmission are required. The results must be added to the grant file as a Class II
Permissive Change.
If the authorized antennas and/or antenna trace design cannot be used, the new antenna and/or
antenna trace designs must be added to the grant file. This is done by a Class I Permissive
Change or a Class II Permissive Change, depending on the specific antenna and antenna trace
design.
• Antennas of the same type and with less or same gain as an already approved antenna
can be added under a Class I Permissive Change.
• Antenna trace designs deviating from the reference design and new antenna types are
added under a Class II Permissive Change.
• For 5 GHz modules, the combined minimum gain of antenna trace and antenna must be
greater than 0 dBi to comply with DFS testing requirements.
2.2 Antenna gain
The antenna gain in each band must not exceed the following:
Wi-Fi Output Power for 2.4GHz band
Channel
Modulation
Channel
bandwidth
Data rates
Maximum power
setting
1 - 11
CCK and DSSS
20 MHz
1, 2, 5.5, 11 Mbps
12 dBm
1
OFDM
20 MHz
6, 9, 12, 18, 24, 36, 48, 54 Mbps
11 dBm