Instructions / Assembly

ManualsBrandsFormufit ManualsPVC Pipe1 in. x 5 ft. Furniture Grade Sch. 40 PVC Pipe in Green

Structural PVC Pipe

FORMUFIT Structural Grade/Furniture Grade PVC Pipe interconnects PVC ﬁtting and

accessory elements to create assemblies and structures. To use this product, follow the

instructions shown below.

1a - Cutting - Hacksaw

Removing Burrs!

https://formuﬁt.com

PRODUCT INSTRUCTIONS

Lay the pipe into a miter box or clamp

to a table. Begin by making a single

saw cut along the top.

Repeat the sawing process with a back

and forth motion until the saw has

completely cut through the pipe.

When cutting with a hacksaw, burrs will be

visible at the ends of the pipe. To remove these,

run a knife or other blade along the inside

perimeter of the pipe to knock the burrs out.

Summary of content (4 pages)

PAGE 1
PRODUCT INSTRUCTIONS Structural PVC Pipe FORMUFIT Structural Grade/Furniture Grade PVC Pipe interconnects PVC fitting and accessory elements to create assemblies and structures. To use this product, follow the instructions shown below. 1a - Cutting - Hacksaw 1 Lay the pipe into a miter box or clamp to a table. Begin by making a single saw cut along the top. 2 Repeat the sawing process with a back and forth motion until the saw has completely cut through the pipe.
PAGE 2
1b - Cutting - Ratcheting Pipe Cutter 1 2 Open the jaws of the plastic pipe cutter and insert the pipe between the blade and cutter body. Apply force on the handles, allow it to retract, then repeat until through the entire pipe. 1c - Cutting - Power Miter Saw 2 1 Align the cut point with the saw blade and secure the pipe in place with clamps on the miter saw fence. All rights reserved.
PAGE 3
2a - Connecting - PVC Cement Apply a small amount of PVC cement to the inside of the PVC fitting or accessory, along the detent or stop. Insert the pipe into the fitting socket and seat fully. PVC cement cures is approximately 30 seconds to 1 minute. 2b - Connecting - PipeRivet Insert the pipe into the fitting. Drill a 1/4” hole on one side of the fitting where the pipe and fitting meet. All rights reserved.
PAGE 4
2c - Connecting - Screws Insert the pipe into the fitting. Drill a 1/8” hole on one side of the fitting where the pipe and fitting meet. All rights reserved. TM, Drive a screw into the hole through the drilled hole. For a flush appearance, use a countersink and countersink screws. ® & Copyright © 2009-2018 FORMUFIT LC https://formufit.