Manual

WWW.FORNEYIND.COM

Generators

This welder can be operated from an AC generator. Ensure that the generator can supply a minimum of 4,000

watts for (120V operation) and (8,000 watts for 230V) of continuous output. The generator must not have an auto-

idle fuel saving feature or must have the option to turn auto-idle off. The generator must run at full speed at all times

while your welder is plugged into it or you risk damaging your welder. Any other power draws on the generator or

anything that reduces the generator RPM may damage your welder.

Extension Cords

For optimum welder performance, an extension cord should not be used unless absolutely necessary. If necessary,

care must be taken in selecting an extension cord appropriate for use with your specific welder.

Select a properly grounded extension cord that will mate directly with the AC power source receptacle and the

welder INPUT POWER CABLE (8) without the use of adapters. Make certain that the extension cord is properly

wired and in good electrical condition. Extension cords must fit the following wire size guidelines:

• for 120V use #12 AWG or larger wire, for 230V use #8 AWG or larger wire.

• Do not use an extension cord over 25 ft. in length.

Since the inhalation of welding fumes can be harmful, ensure that the welding area is effectively ventilated. See the

“Safety Summary” for more details (pages 5-9).

FOR YOUR SAFETY, BEFORE CONNECTING THE POWER SOURCE TO THE LINE

CLOSELY FOLLOW THESE INSTRUCTIONS:

• An adequate two-pole breaker must be inserted before the main outlet. This breaker must be equipped with

time-delay fuses.

• When working in a confined space, the welder must be kept outside the welding area and the ground cable

should be fixed to the workpiece. Never work in a damp or wet confined space.

• Do not use damaged INPUT POWER CABLE (8) or welding cables.

• The welding torch/electrode should never be pointed at the operator or other people.

• The welder must never be operated without its panels attached. This could cause serious injury to the operator

and could damage the equipment.

Ventilation

Additional Warnings