Specification Sheet

42326
S afety Latest Revision: August 2015
D ata Page 4 of 7
S heet Forney Industries, Inc.
19060
Process
Manual welding with heavy formation of spatter and drops
• MMA welding (with basic or cellulose-covered electrodes)
• MAG welding (with CO2 or mixed gases)
• MIG Welding (with high current)
• Self shielded flux core arc welding
• Plasma cutting
• Gouging
• Oxygen cutting
• Thermal spraying
Environmental
Conditions
Operation of machines
• In confined spaces
• At overhead welding/cutting or in comparable constrained
positions
___________________________________________________________________________________
9. PHYSICAL AND CHEMICAL PROPERTIES:
Appearance: Solid
Color: None
Odour: Odourless
Odour Threshold: Not Available
pH Value: Not Available
Specific Gravity: Not Available
Melting Point/Melting Range: 2600 - 2800 ° F, 1425 - 1540° C
Freezing Point: Not Available
Boiling Point/Boiling Range ( ° F @ 760 mmHg) : N/A
Flash point: Not Available
Evaporation Rate: Not Available
Self-in flammability: Not Available
Explosion limits: Not Available
Vapour pressure: (mm Hg): NA
Vapour density: (Air= 1): NA
Density at 20ºC: Not Available
Percent volatile by volume: Not Available
Bulk Density: Not Available
Relative density: 6-9 g/cm3
Solubility: Insoluble in water
Reactivity in Water: Not Available
Partition coefficient: Not Available
Auto-ignition temperature: Not Available
Decomposition temperature: Not Available
Other Information: No available data.
___________________________________________________________________________________
10. STABILITY AND REACTIVITY:
Chemical Stability: This product is stable under normal conditions.
Hazardous Reactions: Contact with chemical substances like acids or strong bases cause generation of gas .
Conditions to Avoid: Not applicable.
Incompatible Materials: Reacts with acid.
Hazardous Decomposition Products: When this product is used in a welding process, hazardous decomposition product
would include those from volatilization, reaction or oxidation of the material listed in section 3 and those from the base metal and
coating. The amount of fumes generated from this product varies with welding parameters and dimensions. Refer to applicable
national exposure limits for fume compounds, including those exposure limits for fume compounds found in section 3.
Manganese has a low exposure limit, in some countries that may be easily exceeded. Reasonably expected gaseous products