Use and Care Manual

Timer

Setting the Timer to Automatic switch-off:

III. How to Use

After using any of the cooking zones, the cooktop will remain

very hot. Even after turning off the entire unit, the surface of the

cooktop will remain hot for some time. The display for the

cooking zones will display an “H” to warn the user that the

surface is hot to the touch. Wait until the “H” is no longer

displayed to clean the unit. You may turn the unit back on even if

the “H” is displayed.

With the desired heating zone Powered ON, press the “Timer”

key. The timer display will blink and show a “00”, Press the “+” or

“-” to increase or decrease to the desired time until the desired

time appears in the display (Choose up to 99 minutes). Once the

Timer is set, if keys haven't been pressed after 5 seconds, it will

begin to countdown, the timer display will remain lit, the

indicator for that particular burner will flash.

If you want to set another burner to switch-off automatically,

repeat the same steps.

If you want to check the remaining time for another zone, press

the “Timer” until the indicator for the desired burner blinks.

If more than one switch-off time is programmed, the shortest

time remaining will show in the display, the indicator for that

particular burner will flash.

Cancelling the timer:

Press the “Timer” until the indicator for the desired burner

blinks, then press the “+” or “-” to set the timer to . The Timer

display will blink for 5 seconds and then turn off, indicating that

the timer of selected heating zone has been cancelled.

When the time

is completed, a “beeping” sound will go off indicating that the

time

is up, and selected heating zone shut off automatically.

press “Timer” key to until the desired timer indicator blink,

“00”