Use and Care Guide

EN
10
2) Lift the door, remove from bottom hinge, turn over 180°, place it on a padded surface to prevent
damage and scratches.
3) Remove the bottom hinge assembly and keep them for later use.
4) Remove the plug buttons from the upper left holes and transfer them to the uncovered holes on the
right side. Be sure to press the plug buttons firmly into the hole.
5) Take the other bottom hinge from the part’s bag and install it on the left bottom.
6) Re-install the top hinge assembly previously removed in step 1 on the opposite side.
7) Remove the block sheet of light switch and re-install it on door’s bottom.
8) Ensure that the door assembly is properly aligned with cabinet before tightening the screws.
CARE AND MAINTENANCE
Cleaning Your Appliance
• Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
• Turn off the refrigerator first and then unplug the unit from the wall outlet.
• Remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution. The
solution should be about 2 tablespoons of baking soda to a quart of water.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
• The outside of the refrigerator should be cleaned with mild detergent and warm water.
• Dry the interior and exterior with a soft cloth.
Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of your
Appliance if you minimize the number of times the drawer is opened. If the power is
going to be off for a longer period of time, you need to take the proper steps to protect
the contents.
Vacation Time
• Turn off the refrigerator first and then unplug the unit from the wall outlet.
• Remove all the contents.