Instruction Manual

Back wall
Mou
nt Hood onto Soffit or Cabinet
Note: If mounting to the underside of a cabinet
with a recessed bottom, install shims to fill the
gap
• Drive mounting screws into the studs until they
protrude by 1/4".
The 1/4" gap will provide
clearance to engage the keyhole slots in the top
of the hood.
• Lift hood to installation position.
•
Lift hood onto mounting screws. Slide back
against the rear wall.
• Tighten mounting screws.
IM
PORTANT: For additional support and to minimize vibration during operation, the hood must be
secured to the back wall. Use wall anchors to fasten bottom back of hood to the wall.
C
ONNECT DUCTWORK
• I
nstall ductwork, making connections in direction of airflow as illustrated
• Wrap all duct joints with duct tape for an airtight seal.
• U
se duct tape to seal the flange connection. Reach inside the hood and push the damper up to b
e
s
ure it moves freely.
Soffit
Engage top
keyhole slots
1/4” gap
Push back
to wall
Add shims
if bottom is
recessed.
Airflow
Duct tape
over transition
Duct tape
over seam
and screw
12