Installation Guide

10
Fe
26
TRADITIONAL INSTALLATION
Step 2: Pre-Drill and Install Brackets
Tip:
• It’s important to double check dimensions to conrm
accuracy of bracket hole locaons before drilling.
 1. UseSpringPunchtomarktheholes.AsshowninFig.13.
 2. Pre-drillbracketholeswitha3/16”[5mm]drillbit.As
 showninFig.14.
 3. AachBrackettothepostswithsuppliedT-25
  Thread-CungScrews.Usetwoscrewsperbracket.Use 
 lowspeedsengondrill.AsshowninFig.15.
 4. Oncetopandboombracketsareinstalled,remeasure 
 bracketspacingtoconrmdimensionsusedin
  Fig.10-12ofstep1(page9&10).AsshowninFig.16.
 5. Removeallmetalshavingsfromdeck,postbase
  cover,post,andpanelbeforebracketisscrewedtopostto
  preventcorrosion.
Fig. 13 Fig. 14
Fig. 12
B
C
B
A
B A
B