Installation Guide

12
Fe
26
TRADITIONAL INSTALLATION
Fig. 19
Mark Here
Mark Here
Mark Here
Mark Here
Half of Panel Length
Center of Panel
Step 3: Cut & Clean Panel
 1. Cutthepanelusingasawwithaferrousmetalcung 
 blade.
 2. Useletosmoothcutedges.
 3. Removeanymetalshavingsanddustwithabrushorrag.
 4. Makesuresurfacestobepaintedareclean.
Fig. 20
Fig. 21
Fig. 22
Step 4: Apply Spray Paint To Cut Areas
 1. Usingapieceofcardboardasamask,applythe1
st
coat of
 Fortresszincbasedtouch-uppaint.AsshowninFig.23.
 2. Allowtodrybeforeapplyingsecondcoat.
Step 2: Measure & Mark Panel Where Cuts Will Be Made
 1. Toensurerailsaresymmetrical,takethemeasurement
  foundinstep1(MeasureThePanelOpeningLength),and 
 divideitinhalf.
 2. Findthecenteroftherailsandmeasureouthalfofthe 
 lengtheachdirecon.AsshowninFig.19.
 3. Marktheselocaonswithapencilonthetopandboom 
 rail.