Installation Guide

14
Fe
26
TRADITIONAL INSTALLATION
Step 2: Install Panel
 1. Installcutpaneltoensurepropert.
Fig. 26
Step 3: Aach Panel To Boom & Top Brackets
 1. Pre-drillholesforscrewsusinga3/16”[5mm]drillbit.
 2. Applyscrewsintoboom&topbrackets.Asshownin
  Fig.27.
Note:
• Onlyonescrewperbracketisneededtosecurethe
  brackettothepanel.
 • Screwsshouldbeinstalledonthesamesideofbrackets.
Fig. 27
Step 4: Aach I-Support To Deck
 1. FastenI-SupporttodecksurfacewiththesuppliedPhillips
 HeadWoodScrew.
Tip:
 • Pre-drillwitha1/16”[2mm]drillbit.
 • UseaBitextendertoinstallscrews.