Installation Guide

Fe
26
TRADITIONAL INSTALLATION
15
Step 1: Install Post Base Cover
 1. Separatethetwo-piecebaseplatecover.Holdoneside 
 paralleltothepostbaseplate.AsshowninFig.29.
 2. Place2ndhalfofthepostbasecoverontheoppositeside 
 ofthepost.Hold2ndpieceslightlyunderthe1stpiece.As
 showninFig.30.
 3. Twistthe2ndcover¼turnandmovepieceunlbothhalf’s
 touch.AsshowninFig.31.
 4. Makesureoneofthelockingpinsonthe2ndcoverengage
 withtheproperslotonthe1stcoverpiece.Asshownin 
 Fig.32.
 5. Oncetherstlockingpinisstarted,turnthe2ndcover 
 piecebackparalleltothepostbaseplate.Oneyouhave
  conrmedbothlockingpinshaveengagedwiththe
  opposingslotslowerbothhalf’soverthepostbaseplate. 
AsshowninFig.33.
POST BASE COVER, BRACKET CAP & PRESSED DOME/BALL CAP
INSTALLATION
Fig. 28
Fig. 29 Fig. 30