Installation Guide

24
Fe
26
TRADITIONAL INSTALLATION
Step 2: Pre-Drill Bracket Holes
 • ReferenceBracketholepre-drillinginstruconson
  page10(Step2:1&2).
Note:
• DO NOTinstallbracketsinthisstep.
COLLAR BRACKET (CB-04): CUTTING DOWN PANEL
 • ReferencePanelcunginstruconsonpages11-13.
Note:
• When measuring the panel opening length for the CB-04
installaon, measure from the inside face of each post.
COLLAR BRACKET (CB-04): PANEL INSTALLATION
Step 1: Install I-Support On Boom Rail
 • ReferenceI-Supporttoboomrailinstruconsonpage13,
 step1.
Step 2: Install Panel
 1. SlideCB-04Bracketsovereachendoftheboom&top
 rails.Makesurethatallsetscrewholesfacethedesired
 direcon.AsshowninFig.44.
 2. SecureBracketsintopre-drilledBracketholesonpostwith
 providedT-25DriveThread-CungScrews.
 3. Pre-drillBracketSetScrewholesonboom&topRail
  usinga3/16”[5mm]drillbit.
 4. SecureBracketontoRailswithprovidedT-25Drive 
 Thread-CungScrews.Uselowspeedsengondrill.As
 showninFig.45.