Installation Guide

28
Fe
26
TRADITIONAL INSTALLATION
Step 2: Pre-Drill Bracket Holes
 • ReferenceBracketholepre-drillinginstruconson
  page10(Step2:1&2).
Note:
• DO NOTinstallbracketsinthisstep.
Collar Bracket
With ATP
Fig. 47
C
A
C
A
B
C
D
E
COLLAR BRACKET WITH ATP: CUTTING DOWN PANEL
 • ReferencePanelcunginstruconsonpages11-13.
Note:
• When measuring the panel opening length for the CB-04
installaon, measure from the inside face of each post.
COLLAR BRACKET WITH ATP: PANEL INSTALLATION
Step 1: Install I-Support On Boom Rail
 • ReferenceI-Supporttoboomrailinstruconsonpage13,
 step1.
Step 2: Install Panel
 1. SlideCB-04Bracketsovereachendoftheboom,middle
 &toprails.Makesurethatallsetscrewholesfacethe
 desireddirecon.AsshowninFig.48.
 2. SecureBracketsintopre-drilledBracketholesonpostwith
 providedT-25DriveThread-CungScrews.
 3. Pre-drillBracketSetScrewholesonboom,middle&top
 Railusinga3/16”[5mm]drillbit.