Installation Guide

Fe
26
TRADITIONAL INSTALLATION
47
 4. Clampthepaneltothepost.Besuretoclampatfour 
 touchpointstokeeppanelinposion.AsshowninFig.82.
 5. Posionbracketparallelwithtoprail&at
  centeredonpost.Make sure inside boom of bracket is
ush with boom of rail. As shown in Fig. 83.
 6. Usepenciltomark top edge of bracket locaononpost.
 7. Dis-assemblethebracketbyremovingthebarrel  
 andscrew.Referencethebracketoponsonpage44.
 8. PlaceBracketBaseonprevioustopedgemark.  
 Centerthebaseonthepostandusepenciltoaddmarks 
 fortwoscrewholelocaons.AsshowninFig.84.
Note:
• Forbestresults,besurebracketbasesarecenteredon 
 postswhenmakingmarks.
Fig. 81
Fig. 80