Installation Guide

Fe
26
TRADITIONAL INSTALLATION
53
STAIR BRACKET (SSB-04): BRACKET INSTALLATION
Bracket Opons
• When installing SSB brackets,Idenfythe4brackets 
 (LT,ST,LBandSB)bytheleersstampedineachpart.
• Referencetheinstalledpanelimageandtheplacementof 
each SSB bracket onpage51.
Step 1: Boom Bracket Installaon
 1. Posionwood2”x4”(actual1-1/2”x3-1/2”[38mmx 
 89mm]) betweenposts.AsshowninFig.90.
 2. Posionboombracketscenteredatonpost&wood
2”x4”(actual1-1/2”x3-1/2”[38mmx89mm]).Use
  penciltomarktopedgeofbracketlocaononpost.As 
 showninFig.91.
 3. Disassemblethebracketbyremovingthebarreland 
 screw.Referencethebracketoponsonpage52.
 4. Placebracketbaseonprevioustopedgemark.Centerthe
base on the post and use pencil to addmarksfortwo 
 screwholelocaons.AsshowninFig.92.
Note:
 • Besurebracketbaseiscenteredonpostwhenmarking 
 holelocaons.
Fig. 90 Fig. 91