Installation Guide

54
Fe
26
TRADITIONAL INSTALLATION
Fig. 92
Step 2: Boom Bracket Installaon Connued
 1. UseSpringPunchtomarktheholes. AsshowninFig.93.
 2. Drilloutbracketholewitha3/16”[5mm]drillbit.As
 showninFig.94.
 3. UseT-25screwstoaachthebasetothepost.Beginwith 
 boomholethentop.AsshowninFig.95.
 4. Keepbracketbasecenteredasyouinstallsecondscrew.
 5. Insertbarrel&screwtore-assemblebracket.
 6. Tightenbarrel&screw.AsshowninFig.96.
Note:
• LowerPostmayneedtobeunmountedtoinstallbracket 
 thenremounted.
Fig. 93 Fig. 94