Installation Guide

Fe
26
TRADITIONAL INSTALLATION
9
Step 1: Mark Bracket Hole Locaons
 1. Markthecenterlineofeachpostwithapencil.
 2. TakemeasurementsusedinFig.10-12tomarkboom 
 andtopbracketholelocaonsontoposts.
Tip:
• Remove all metal shavings from deck, post base cover,
post, and panel before bracket is screwed to post to
prevent rust stains.
UNIVERSAL BRACKET (UB-04): BRACKET INSTALLATION
*DimensionAposionsboomedgeofrail3-3/4”[95mm]abovedecksurface.
*DimensionAismeasuredfromtheboomsurfaceofpostbase.
Fig. 10
UB-04 Bracket Hole Locaons: 3-3/4”[95mm]AboveDeckSpacing
Pre-drill Dimensions: Pre-drillingwitha3/16”[5mm]drillbitisrequired
34” [864mm] Panel
38” [965mm] Panel
B
1/2”[13mm]
1/2”[13mm]
1/2”[13mm]
C
37”[940mm]
41”[1041mm]
43”[1092mm]
40” [1016mm] Panel
A*
4”[102mm]
4”[102mm]
4”[102mm]
Fig. 11
UB-04 Bracket Hole Locaons: 2”[51mm]AboveDeckSpacing
Pre-drill Dimensions: Pre-drillingwitha3/16”[5mm]drillbitisrequired
*DimensionAposionsboomedgeofrail2”[51mm]abovedecksurface.
*DimensionAismeasuredfromtheboomsurfaceofpostbase.
1/2”[13mm]
41-1/4”[1048mm]
40” [1016mm] Panel
2-1/4”[57mm]
B C
A*