Use & Care Manual

17
Use
Cooktop
Turning on the Gas Burner
Press and turn the corresponding knob counter-clockwise to the MAX position.
When it is lit, hold the knob down for approximately 10 seconds, then release it and adjust flame intensity, being careful to
position the knob in the area between maximum and minimum (included) and never between maximum and zero to prevent
turning it o unexpectedly.
The burner may go out when you release the knob: this means that the thermocouple is not hot enough. If it does not ignite
within 15 seconds, wait 1 minute before trying again.
Dual Flame Burner
The dual flame burner has two separate flame rings to provide a complete heat regulation from the high power to simmering.
To set:
1) Push and turn the knob counter clockwise within the main high and low range, when the burner is turned on, the Simmer
flame ring ignite and remain on.
2) Set desired temperature within the high and low simmering range;
3) Continue turning the knob counter-clockwise to ignite both the flame rings and set the burner at its high power range.
Do not operate a burner using empty cookware or without cookware on the grate.
Do not touch the burner when the igniters are clicking
Do not let the burner flame extend beyond the edge of the pan.
Turn o all controls when not cooking.