Use & Care Manual

27
Following there is a procedure:
1) Remove the burner cap from the burner base and clean according to cleaning section.
2) Remove the burner spreader. Clean the gas tube opening and burner port according to cleaning section.
3) Clean the burner base with a damp cloth (keep the gas injector area free of cleaning agents and any other material
from entering the injector orifice).
4) Replace the burner spreader and cap, making sure the alignment pins are properly aligned with the slots.
5) Turn on the burner.
If the burner does not light, check cap and spreader alignment. If the burner still does not light, do not service the gas burner
yourself. Contact a trained repair specialist.
Be sure when lighting the burner:
• Gas spreader is seated correctly and pin is properly aligned with burner base slot.
• Cap is seated correctly and pin is properly aligned with gas spreader slot.
Burner Ports
Check burner flames occasionally. A good flame is blue in color, not yellow. Keep this area free of soil and do not allow spills,
food, cleaning agents or any other material to enter the burner ports.
Cleaning the Oven
For a good preservation of the oven it must be cleaned regularly after it has cooled down.
• Remove all removable parts.
• Clean the oven grids with hot water and non-abrasive detergents, rinse and dry.
• To make cleaning easier, it is possible to take the door and/or the glass o (refer to the maintenance paragraph).
• At the end of these operations, to dry the damp parts thoroughly. It is advisable to turn the oven on for a maximum of 15/20
minutes after the use of specific cleaning products, in order to eliminate any residues from the inside of the oven.
• Do not use abrasive detergents or metal scrapers to clean the oven door glass as this may scratch the surface of the glass,
causing its breakage.
• Make sure oven is cool and power to the oven has been turned o before removing the door. Failure to do so could result in
electrical shock or burns.
• The oven door is substantial. Use both hands to remove the oven door. The door front is glass.
• Handle carefully to avoid breakage.
• Grasp only the sides of the oven door. Do not grasp the handle as it may swing in your hand and cause damage or injury.
• Failure to grasp the oven door firmly and properly could result in personal injury or product damage.