Installation Guide

14
STEP 8: SECURE POSTS
Components Needed
Square Posts
Bottom Post Brackets
3/8” x 2-3/4” anchors
Tools Recommended
FIRST: Attach square post at ground to
secure assembly. Mark post position on slab.
Insure that post are plumb in both directions.
SECOND: Using the pre-drilled holes in
bottom bracket as a guide, mark both holes on
the slab or surface.
THIRD: Drill 3/8” diameter holes in slab or
surface with masonry bit (not included) and
fasten bottom post bracket to slab with two
3/8” x 2-3/4” wedge anchors.
Repeat this step for each post location across
entire assembly.
NOTE: Keep post secured to ladder with ropes until all post are secure into slab or surface.