Installation Guide

PATIO COVER INSTRUCTION SHEETS
[e-mail]
4/8/2022 10
PATIO COVER INSTRUCTION SHEETS
STEP 2B: ONLY for Double Beam Preparation & Assembly
Follow & Complete STEP # 2A : 3" EDGE Beam Preparation STEPS A through G.
Find the 8 "Setback Brackets."
Measure and place a pencil mark on the
prepared 3" Edge Beam, 6” from each side
of the Top Post Brackets (I).
Set the brackets on the top side of the prepared 3” Edge Beam
at the 6” pencil mark and fasten each side using 4 #14 tek screws 2
on each side.
6 Setback Brackets should now be fastened to the 3" Edge Beam.
Measure between the Top Post Brackets and mark the midpoint on the 3" Edge Beam.
Center the Setback Brackets on the pencil mark and fasten using 4 #14 tek screws on each side.
Set two pieces of the 3" Edge Beam (#F) on a smooth flat surface (being careful not to scratch it).
Mark the Edge Beam Splice (#G) at 12” & slide into one Edge Beam (#F) to the 12" mark. Then slide
the second Edge Beam over the splice and butt up against the first Beam.