Installation Guide

PATIO COVER INSTRUCTION SHEETS
[e-mail]
PATIO COVER INSTRUCTION SHEETS
[e-mail]
LifeRoom Optima Installation Guide
STEP 4A: Measuring, Leveling,
Cutting, Fastening 3 x 3 Posts (#J)
Radius Corners to Edge Beam
(#F) NOTE: the bottom of the 3" Edge
Beam (#F) should never be lower than
80”. Place a level on the front edge of
the slab to determine which is the
LOW Side (the left side or the right
side). After determining the LOW side,
measure from the slab up to the
bottom of the Hanging Channel (#B)
on that LOW side.
STEP 4B: Subtract 3 ½” from
your measurement AND a
minimum 1/2" per foot of your roof
panels. If your roof panels are 10ft
= 5" OR if roof panels are 12ft = 6“.
Example: if you bought a 12 feet
deep x 22 feet wide LifeRoom
Optima and you measured 98” to
the bottom of Hanging Channel,
98" - 3-1/2" = 94 1/2“. Then 94-1/2"
- 6" = 88 ½”. Cut your first post to
this measurement.
STEP 4C: Slip the first Post tightly
over the Top Post Bracket (#I),
fastening through the Post into the
internal bracket leg, using 4 #14 x
1-1/4" tek screws evenly spaced on
both sides.