Installation Guide

PATIO COVER INSTRUCTION SHEETS
[e-mail]
4/8/2022 7
PATIO COVER INSTRUCTION SHEETS
LifeRoom Optima Installation Guide
STEP 2A: 3” Edge Beam
Preparation:
Set two pieces of
the 3" Edge Beam (#F) on a
smooth flat surface, being careful
not to scratch them.
STEP 2B: Mark the Edge Beam Splice
at 12” and slide into one Edge Beam (#F)
to the 12” mark. Then, slide the 2
nd
Edge Beam
over the Splice and butt up against the first Beam.
STEP 2C: Take one Top Post Bracket and
center it over the butt joint of the 2 Edge
Beams. Fasten using 2 #14x1-1/4” tek screws
through the face of the Top Post Bracket into
one Edge Beam, and then into the Beam Splice (#G).