Installation Guide

Step 2:
OPTION A: Prepare existing countertop
1. Make sure existing countertop cut-out opening is the proper size. Set the new
sink into opening. The sink rim should rest evenly on the countertop. Slight
2.
sawing.
3.
OPTION B: Prepare a new countertop using the sink as
a template
1. Carefully place the sink upside down on the
countertop at the desired position. Trace the outline
of the sink onto the countertop. Do not cut along
this line.
2. Draw a line 3/8” (9mm) inside the sink outline.
Measure the cut-out line you just drew and
compare to all sink dimensions. The cut-out should
be approximately 3/4” (19mm) smaller than the
overall sink dimensions.
3. Verify both measurements.
4. Drill a pilot hole inside the cutting line.
5. Using a jigsaw, cut along the inside line to create
the opening in the countertop.
Step 3: Mounting clips
1. Turn sink upside down onto a clean, soft surface.
2. Insert front hook into clip base. Push clip backward
into base until the clip clicks into place.
Step 4: Install accessories
Attach faucet and drains to the sink. Use plumber’s putty or silicone sealant
under the faucet base and under the top flange of the drain to provide a
leak-proof seal.
Step 5: Insert sink and tighten mounting clips
1. Place a continuous and generous bead of silicone
sealant or plumber’s putty around the entire
perimeter of the countertop rim. This serves as a
watertight seal.
2.
3.
Lift sink, turn face-up and lower into the countertop
opening.
4.
Line up front rim with the front edge of the counter.
Underneath the countertop, begin tightening clips
with a screwdriver or power driver in an even
fashion, alternating sides while tightening until
until the entire rim is sealed.
Length
Width
Step 2
Countertop
Using a 2" hole saw, drill
a hole on the inside of the
line that was traced using
the cut-out template.
Countertop
Using a jigsaw, cut along outline
traced on countertop.
1
4
5
2
OPTION B: 1
4
2
5
Faucet base
of drain
Step 4
Step 5
Clip Base
Step 3