Owner's Manual

Page 11For technical questions, please call 1-888-866-5797.Item 58307
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Figure Q:
WARNING! Do not force the panel beyond its
listed height range. If the pole is overextended,
the hoist may become stuck or tip.
CAUTION! The Wire Ropes must be
aligned and wound tightly and evenly on
the spool to prevent tangling. If they start
winding unevenly, lower the load and
carefully adjust them before continuing.
3. Raise the Telescoping Assembly so that the
holes of the inner post align with the Attached Pin
opening, then lock in place with the Pin Lever,
or, slide the Square Pin through the Inner Pin
holes above the Outer Post. See Figure S.
Square Pin
Attached PinAttached Pin
Inner Post
Pin Lever
Outer Post
Figure R:
Lowering the Cradle
1. Install the drywall panel correctly
before lowering Cradle.
2. Push and hold the Winch Wheel slightly
forward to support the weight of the Cradle.
3. Release the Pin with the Pin Lever (see Figure S),
then operate the Brake Handle with your left hand
and rotate the Winch Wheel counterclockwise
with your right hand to lower the Cradle.
CAUTION! Do not release control of the
Wheel Handle as the Hoist is lowering or the
Cradle may lower forcefully and cause injury.
4. After each use, lower the Cradle completely and
clean all surfaces of the Hoist with a clean cloth.
Note: If operation becomes rough,
lubricate the post with candle wax.
Storing the Hoist
When not in use for an extended period, the
Hoist can be disassembled as follows:
1. Lock the Caster Wheels.
2. Fully lower the Telescoping Asm.
3. Retract the Extensions and close the Support
Hooks on the Cradle. Secure all in place.
4. Remove the Crossarms, then remove the Cradle.
5. Remove the Telescoping Asm.
6. Depress the Slide Lock Ring and fold
the Tripod Base legs together until the
Slide Lock Ring locks in place.
7. Wipe dust and dirt from all parts
with a clean cloth if needed.
8. Store all components in a safe location
indoors out of reach of children.