Owner's Manual

Page 5For technical questions, please call 1-888-866-5797.Item 58307
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Tripod Setup
1. Stand the Tripod Base on the floor,
resting on its Caster Wheels.
2. Press down on the Slide Lock Ring on
the center Leg. Hold the Ring down while
swinging the remaining two Legs forward
until the Yoke Ring snaps into the locking
hole near the center of the tripod.
Slide
Lock
Ring
Figure B:
Locking Caster Wheels
Lock the Caster Wheels by pressing down with
your foot on the front side of the tilting lock.
Note: To unlock the Caster Wheels, press
down on the back side of the tilting lock.
Lock
Unlock
Figure C:
Telescoping Assembly
Set the Telescoping Asm. into the Tripod Base.
Back View of Tripod
showing “V” shaped
Flanges:
Front Assembled View:
Figure D:
WARNING! The Telescoping Asm. must fit over both “V”
shaped flanges shown in Figure D (top photo) and at
right. The Telescoping Asm.
must sit exactly vertically. If
the main bar sits at an
angle, then the unit is not
tucked into the inner “V”
shaped flange.
Outer
Flange
Inner
Flange
Telescoping
Asm.
Tripod
Base