Owner's Manual

Page 6 For technical questions, please call 1-888-866-5797. Item 58307
SAFETY OPERATION MAINTENANCEASSEMBLY
Winch Wheel Setup
1. Attach the Handle to the Wheel using the
threaded shaft and nut. Leave some play in
the Nut so that the Handle turns freely.
Support Post
Slide Bar
Telescoping
Asm.
Wheel
Handle
Brake
Figure E:
2. To extend the Wheel to its working position:
a. Check that the Caster Wheels are
locked before beginning.
b. Hold the Brake in your left hand and the
Wheel Handle in your right hand. Rotate
the Wheel forward slightly while you lift
on the brake to release the brake.
Figure F:
c. While still holding the brake up, grasp the
Support Post with your right hand and pull the
wheel assembly toward you, pulling evenly.
d. Push the Wheel Asm. back toward the frame
slightly, to engage the Slide Bar Lock, securing
the Winch Wheel Asm. in the working position.
Slide Bar
Lock
(engaged)
Figure G:
CAUTION! Before proceeding, make sure that
the Slide Bar Lock is rotated as far as it will
go clockwise, so that it is fully engaged.
Attach Cradle to Frame
Insert the Mounting Pin (13), on the
bottom of the Cradle, into the opening
in the top of the Telescoping Asm.
Cradle Beam
Telescoping
Asm.
Mounting Pin
Figure H: