Owner's Manual

Page 9For technical questions, please call 1-888-866-5797.Item 58307
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Tilt Latch
The Tilt Pin allows the Cradle to tilt to adjust the
panel as needed for installation on sloped ceilings
or walls. When the Cradle is locked with the Tilt
Pin through the aligned holes in the Cradle Beam
and Telescoping Asm., it will support a drywall
panel horizontally for flat ceiling installation.
Cradle
Beam
Telescoping
Asm.
Tilt Pin
Locked position:
R-Pin
Figure M:
To unlock the Cradle for different angles,
slide the Tilt Pin out of the holes, rotate
the Cradle to its tilted position.
WARNING! To prevent serious injury from falling load:
Only remove the Tilt Pin shown in Figure M. Do not
remove the Hinge Pin on the opposite side of the Cradle.
Winch Asm. & Winch Wheel
1. The Winch Wheel is used to raise and lower
the Cradle, which holds the panel. This
is done by means of a Wire Rope which
wraps around a Spool in the Winch.
Support Post
Slide Bar
Telescoping
Asm.
Wheel
Handle
Brake
Figure N:
2. If necessary, you can grasp the end of the
Support Post for leverage when raising a panel.
CAUTION! Pay attention to the action of the Wire
Rope when operating this tool. Do not allow your
hands, clothing, hair or jewelry to come near the Wire
Rope. If these become caught in the Wire Rope,
you can be injured. Do not allow the Wire Rope to
become tangled or jammed during operation.
CAUTION! Align the Wire Rope
and wind it tightly and evenly on
the spool to prevent tangling.
If they start winding unevenly: stop, reverse
direction to loosen the rope, then carefully
adjust them before continuing.
3. Raise the Telescoping Assembly and lock in
place through the holes in the post either with
the attached Pin and Pin Lever, or, above the
Outer Post with the Square Pin. See Figure O.
Square Pin
Attached PinAttached Pin
Inner Post
Pin Lever
Outer Post