Installation Guide

INSTALLATION AND SETUP
Please read the product setup instructions carefully. Do not operate this product in
windy conditions.
Find a flat area of either grass or gravel for your product. Do not set up your
inflatable on a slope. Doing so may prevent the inflatable from inflating properly
or standing correctly. It may also present a safety hazard. Be sure that the area
is clear of leaves, loose dirt and/or standing water as any of these can stain the
product or damage the fan.
Carefully remove the inflatable and included items from the box. Set the stakes,
ropes and clips aside. You will need those after fully inflating your inflatable for the
first time.
Lay your inflatable out on the ground. The fan will be on the back side of the
inflatable. Ensure that the deflation zipper on the back of the inflatable is closed.
Plug the fan into a Class A GFCI-protected receptacle to start inflating your
inflatable.
For your first inflation, you will need to help your inflatable inflate properly. Ensure
that all of the extremities are positioned correctly, untwisting anything that may
have become tangled during unpacking and setup. For taller inflatables, you will
want to connect the tie downs to the upper fabric (or metal) loops before you fully
inflate. Otherwise, the loops may be too high to reach.
When fully inflated, locate all of the tie-down points around the base. Place a stake
through the loop and press the stake about 2/3 of the way into the ground (you will
insert these fully later). These stakes help hold the inflatable upright and prevent
the wind from moving your inflatable.
Note: If your inflatable is taller than 10 feet, you will need assistance to safely position
and secure your inflatable.