Installation Guide

For inflatables under 9-feet tall, install at least three upper tie downs. For inflatables
over 10-feet tall, you will need to install four or more upper tie downs, depending on
the inflatable.
Attach each rope to a clip and attach the clip onto the upper fabric or metal loops.
(If clips are not included, tie each rope to directly to the loop.) Tie the ropes to
the additional ground stakes and secure the stakes about 2/3 of the way into the
ground (you will insert these fully later).
The angle of the rope to the ground should be 45 degrees (see diagram above). To
achieve a 45-degree angle, the stake distance (SD) from the inflatable should be
roughly equal to the loop height (LH) on the inflatable.
To properly secure your inflatable, install the upper tie downs according to the
above graphic. Note that two of the side tie downs must angle forward by at least
30 degrees. Adjust stakes as needed to assure that the inflatable is fully upright and
positioned correctly. When the inflatable is correctly positioned and all stakes have
been placed, push all of the stakes fully into the ground.
To achieve a proper 45º Angle,
Stake Distance (SD) = Loop Height (LH)
For example, if the Loop Height (LH) is 6’,
the stake should be placed
6’ away from the inflatable
Overhead View