Instructions / Assembly
1) Schematic diagram
2) Component list
No.
Name
Number
1
Lamp top
1
2
Lamp holder
1
3
Lamp post (17in）
2
4
Adapter (12V AC 500mA)
1
5
Extended wire (137in)
1
6
Power wire (137in)
(inside lamp post: 59, outside: 78in)
1
7
Additional base
1 set（4）
8
Ground nail
4
9
Lamp base
1
10
Square base
1
11
Brand
1
12
Lamp post joint
1
13
Wreath+ bowknot
1 set
14
Power wire of lamp holder
1
15
Screw
4+1
Note: 1,2,3,4,5,6 are all wire joints.
3) Assembling steps
Please assemble the product from the bottom to the up,
following the main steps below:
1. Install lamp base
A. Assemble lamp base (9) and square base (10) with 4
screws:
B. Assemble 4 pieces of additional base (7) into a whole,
and then assemble the whole additional base (7) with the
lamp base (9).
Note: The additional base (7) is especially designed to
fasten the street lamp more securely. The additional base
does not need to be installed if the following applies- street
lamp is installed on a flat ground and there is no external
force (such as high wind or man-made interference) to
bring it down or if the street lamp is used outdoor and it can
be fixed on the ground by fastening ground nails. It is to
your discretion on whether to install the additional base (7)
according to the actual condition.
2. Install lamp post
Screw the 2 lamp posts (3), lamp post joints (12) and
square lamp base (10) together according to the sequence
shown in the figure below. Note: Every screw thread must
be tightened; otherwise, the lamp posts may lean or get loose!
Caution
This product (especially the lamp holder) is
fragile, do not exert too much strength or drop it
during the assembly and use. Be sure to fix it on
the wall securely.
This product is waterproof; but it is necessary to
keep the lamp in the vertical direction to ensure
water drains correctly.
Please assemble it in strict accordance with
the steps and requirements specified in the
instruction to ensure safety and reliability
during the installation.