User's Manual
Table Of Contents
- 1 Device pinout
- 2 Device terminal functions
- 3 Electrical Characteristics
- 4 Radio Characteristics
- Firmware versions
- 5 Device terminal description
- 6 Application information
- 7 Package information
- 8 Certifications
- 9 RoHS And REACH Statement
- 10 Tape and Reel information
- 11 Ordering information
- 12 Document history
- Acronyms and definitions
Rev: e
© 2030 Free2move AB
Page 10(45)
Extended range Bluetooth
Module - F2M03GXA
Datasheet
BASEBAND and RF
HCI
LINK MANAGER
HCI
Host
F2M03
BASEBAND and RF
HCI
LINK MANAGER
L2CAP
Device
Manager
RFCOMM SDP
Port Entity
Application
Host
F2M03
Bluetooth stack
Application
Wireless UART
Free2move’s Wireless UART (WU) firmware is intended to replace the serial cable(s) connecting portable
and/or fixed electronic devices. Key features are robustness, high configurability, high security, low
complexity and low power. The WU firmware is compliant with the Bluetooth Serial Port Profile (SPP) for
setting up emulated serial cable connections between connected devices. There is no additional need for
drivers or an external host with Bluetooth software when using the WU firmware. When a successful
Bluetooth connection is established the data channel and the voice channel can be used simultaneously or
separately. All information sent/received at the data/voice interface of the WU unit is exchanged
transparently via Bluetooth with the connected remote device.
HCI (Standard Two-Processor Solution)
For the standard two-processor solution, where the split between higher and lower layers of the stack takes
place at the HCI, a complete Bluetooth stack is needed in the external host. It is often preferable to use this
solution when the host is a personal computer of some description. However, in general this category can
include any computing platform with communications capability that is not resource limited.
Free2move do not offer a host stack.
Embedded Solution
This version of the stack firmware requires no host processor. All software layers, including application
software, run on the internal RISC processor in a protected user software execution environment.
The embedded solution can be used for a single chip Bluetooth product. One example is a cordless
headset. However this solution is equally applicable to any small wireless device that would benefit from a
single processor solution.
Free2move can offers among others the following single chip solutions upon a custom request*:
• Headset / Hands Free
• Human Interface Device; Mouse, keyboard etc (HID)
• Dial Up Network (DUN)
• Audio Gateway Profile (AGP)
• OBEX
• Onboard application (development of customer specific applications)
*Please consult your reseller for more information about custom firmwares.
HCI, (Two-Processor
Architecture)
RFCOMM, (Embedded
Two-Processor Architecture)