User's Manual
Table Of Contents
- 1 Device pinout
- 2 Device terminal functions
- 3 Electrical Characteristics
- 4 Radio Characteristics
- Firmware versions
- 5 Device terminal description
- 6 Application information
- 7 Package information
- 8 Certifications
- 9 RoHS And REACH Statement
- 10 Tape and Reel information
- 11 Ordering information
- 12 Document history
- Acronyms and definitions
Rev: e
© 2030 Free2move AB
Page 20(45)
Extended range Bluetooth
Module - F2M03GXA
Datasheet
The UART interface is capable of resetting the Free2move module upon reception of a break signal. A
Break is identified by a continuous logic low on the UART_RX terminal, as shown in figure below. If tBRK is
longer than a special value, defined by the Free2move firmware a reset will occur. This feature allows a
host to initialise the system to a known state. Also, the F2M03 can emit a Break character that may be used
to wake the Host. The above capabilities are not supported in the standard firmware, please contact
Free2move for more information.
Break signal